New V2 version. microSD card reader for all Amiga models. SDBox V2 is a small device that plugs on the Amiga's parallel port and lets you use standard microSD cards. Please note SDBox is very picky with SD cards. A 100% compatible SD card is available as option.

New trapdoor memory expansion for Amiga 600. This expansion lets you to add 1MB of CHIP RAM to your Amiga 600. The on-board Real Time Clock is available as option. It is also the perfect complement to our 4MB Fast RAM Memory Expansion. 

For Amiga A600. PiStorm is an adapter which uses a Raspberry Pi to provide a CPU accelerator, RTG graphics card, hard disk interface, and others enhancements. CPU relocator, Raspberry Pi 3A+, and a pre-configured SD card are available as option. If you want to 1MB of CHIP RAM, please check our Trapdoor Memory Expansions for Amiga Amiga 600.

For A1200 and A600. The A1200/600 CF-IDE buffered adapter allows to connect a CF card and an additonal IDE device to your Amiga 1200 or Amiga 600. It features one CF card slot, one 44pin IDE connector, a buffer for 24 IDE signals to stabilize data transfers, and also a coverter to fix well knowed issues with the IDE LED of Amiga 1200/600.

For Amiga 500/600/1200. The internal version of Gotek let you mount the drive inside your Amiga 500, 500+, 600, or A1200 case, and give you full access to the controls from the outside. This version comes with two LEDs, a buzzer which emulates the floppy drive sound. OLED display is available as option. The Gotek Floppy Emulator allows you use USB memory sticks instead floppy disks on Amiga and other systems. This device is flashed with the last FlashFloppy firmware for Amiga/Atari/Amstrad/Sinclair/Acorn/IBM-PC computers or the last universal HxC firmware for Amiga, Atari, Amstrad, Sinclair, and any computer or device with a Shugart/PC floppy interface.

RGB2HDMI FFC interface is an adapter which uses a Raspberry Pi to covert the RGB signal of your Amiga 600 to digital HDMI. This solution adds pixel-perfect HDMI output to Amiga computer and lets you connect monitors and TVs with an HDMI input. RGB2HDMI software is supplied on the included SD card. The necessary Raspberry Zero board is available as a product option.

Re-stock: TBA. A608mini is an 8MB Fast RAM expansion card for Amiga 600 with the extremely small size (5 x 3.5cm).

For A1200, A600, and any other hardware with a 2,5" IDE interface. The 2.5" Buffered IDE interface allows to connect to your Amiga up to 2 IDE devices, like hard disks, Compact Flash or SD2IDE adapters. It features a buffer for 24 IDE signals to stabilize data transfers and also fix well knowed issues with the IDE LED of Amiga 1200/600.

For Amiga, Atari ST/STe, and Commodore C64 with GEOS. This adapter lets you to connect real USB mice, and not only mice with the rare "USB to PS/2" specification. Thanks to his built-in USB stack, the device is compatible with the HID protocol used by the common USB mice and joypads without need to install additional software drivers. Amiga 600 mouse port compatible.

For Amiga 600. This low cost memory expansion provides 4MB of Fast RAM to your A600 and lets you run the Amiga software that requires Fast Memory, making it a great choice to play WHDLoad games or to install the AmigaOS 3.1.4 operating system. It is also the perfect complement to our Amiga 600 1MB Chip Memory Expansion.